Version
menu_open

Adding File Packages to a Project

You can add as many packages to a project as required. After creating your packages, you can define the byte alignment of the packages using the Block Size property. The number you specify will depend on the requirements of each platform's I/O device.

[Note] Note

For more information about block size and the constraints of each platform's I/O device, refer to the Streaming > Low-Level I/O section of the SDK documentation.

To add file packages to a project:

  1. From the Packages list, click Add.

    A new packages is added to the Packages list.

  2. Replace the default name with one that best represents the new package.

  3. Press Enter.

  4. Repeat steps 1-3, until all your packages have been created.

  5. To specify the number of bytes upon which the data within your packages is aligned, enter a value in the Block Size field. The number you specify will depend on the requirements of each platform's I/O device. The typical value for each platform is 1.

    [Note] Note

    A block size of 1 means that there is no alignment.


Was this page helpful?

Need Support?

Questions? Problems? Need more info? Contact us, and we can help!

Visit our Support page

Tell us about your project. We're here to help.

Register your project and we'll help you get started with no strings attached!

Get started with Wwise