Wwise SDK 2022.1.7

Sets the Audio Device to which a master bus outputs. This overrides the setting in the Wwise project.
Can only be set on top-level busses. The Init bank should be successfully loaded prior to this call.

Note: This function is useful only if used before the creation of an output, at the beginning of the sound engine setup. Once active outputs using this Bus have been created, it is imperative to use AK::SoundEngine:ReplaceOutput instead to change the type of output. Returns AK_IDNotFound when either the Bus ID or the Device ID are not present in the Init bank or the bank was not loaded AK_InvalidParameter when the specified bus is not a Master Bus. This function can be called only on busses that have no parent bus.

Parameters

in_idBus	Id of the master bus
in_idNewDevice	New device shareset to replace with.