Version
menu_open

Envelope Sensitivity and Manual Editing

Once you enable the Envelope, you can preview the result by opening the source editor (next figure). If you are unhappy with the precision and/or number of points, you can change the value of the sensitivity slider in the Envelope Tracking group box (see Figure 30.19, “HDR tab in Property Editor”). You can work with a group of sounds by enabling the envelope and setting the sensitivity on a higher-level sound structure, an actor-mixer for example. Note that the effect of the sensitivity is dependent on the original audio data, and may therefore be different for different variations of similar sounds. You can also edit the envelope manually for each sound; set the sensitivity control so that you obtain a curve that is close to the desired result, and move, remove or add new points.

Figure 30.18. Source editor in RMS mode, with envelope display

Source editor in RMS mode, with envelope display

Figure 30.19. HDR tab in Property Editor

HDR tab in Property Editor


Was this page helpful?

Need Support?

Questions? Problems? Need more info? Contact us, and we can help!

Visit our Support page

Tell us about your project. We're here to help.

Register your project and we'll help you get started with no strings attached!

Get started with Wwise