You can move the entry and exit cues to different locations on the timeline and in so doing extend or decrease the pre-entry and post-exit areas in your segments.
To drag entry and exit cues for a segment within a selected clip:
Select and drag the cue left or right along the segment.
To edit the cue time:
On the timeline, right-click the entry or exit cue that you want to edit.
From the shortcut menu, select Show in Multi Editor.
The Multi Editor opens.
In the Multi Editor, enter the desired time in the Cue Time (Ms) text box, or drag the slider.
Close the Multi Editor.
To move entry and exit cues for a segment to the ends of a selected clip:
Right-click the clip where you want to define the entry and exit cue locations.
From the shortcut menu, select Move Entry/Exit Cues to Selection.
The Entry and Exit cues are positioned at the beginning and end of the selected clip.
![[Tip]](/images/2022.1.12_8435/?source=Help&id=tip.png) | Tip |
|---|---|
When moving the entry cue, the whole segment will move with the entry cue (including clips and other cues). When holding the CTRL key and dragging the entry cue, only the entry cue will move. |
Was this page helpful?
Need Support?
Questions? Problems? Need more info? Contact us, and we can help!
Visit our Support pageTell us about your project. We're here to help.
Register your project and we'll help you get started with no strings attached!
Get started with Wwise